Users Guide

Version Description
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series TeraScale.
Usage Information
This command turns on BGP soft-reconguration inbound debugging for IPv6 unicast routes. If no neighbor
is specied, debug is turned on for all neighbors.
ipv6 prex-list
Congure an IPv6 prex list.
S4820T
Syntax
ipv6 prefix-list prefix-list name
Parameters
prex-list name Enter the name of the prex list.
NOTE: There is a 140-character limit for prex list names.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant FTOS
Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
neighbor soft-reconguration inbound
Enable a BGP soft-reconguration and start storing updates for inbound IPv6 unicast routes.
S4820T
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor for which you want to start storing inbound
routing updates.
peer-group-name Enter the name of the peer group for which you want to start storing inbound
routing updates.
474
Border Gateway Protocol