Users Guide

Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command enables soft-reconguration for the specied BGP neighbor. BGP stores all updates for
inbound IPv6 unicast routes the neighbor receives but does not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results applied on
the neighbor.
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the internet and connecting
multicast topologies between BGP and autonomous systems (AS). FTOS MBGP is implemented as per IETF RFC 1858.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
S4820T
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address prex-
length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
summary Display a summary of RPF routes.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant FTOS
Command Line Reference Guide.
Border Gateway Protocol
475