Users Guide
Command History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.4(0.0) Introduced on the S4810, S4820T, and S6000.
Usage Information You can activate VRF application on a device by using the feature vrf command in CONFIGURATION
mode. The no feature vrf command is not supported on any of the platforms.
Example
Dell#show feature
Feature State
------------------------------
VRF enabled
Command Modes
To navigate and launch various CLI modes, use specic commands. Navigation to these modes is described in the following sections.
BGP ADDRESS-FAMILY Mode
To enable or congure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, refer to Border Gateway Protocol
IPv4 (BGPv4).
To enable or congure IPv6 for BGP, use BGP ADDRESS-FAMILY mode.
To enter BGP ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER BGP mode.
2. Enter the command address-family
3. Enter the protocol type.
• For IPv4, enter ipv4 multicast. The prompt changes to include (conf-router_bgp_af) for IPv4.
• For IPv6, enteripv6 unicast. The prompt changes to include (conf-router_bgpv6_af) for IPv6.
CLASS-MAP Mode
To create or congure a class map, use CLASS-MAP mode. For more information, refer to Policy-Based QoS Commands.
To enter CLASS-MAP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the class-map command then enter the class map name. The prompt changes to include (cong-class-map).
You can return to CONFIGURATION mode by using the exit command.
CONFIGURATION Mode
In EXEC Privilege mode, use the configure command to enter CONFIGURATION mode and congure routing protocols and
access interfaces.
To enter CONFIGURATION mode:
1. Verify that you are logged in to EXEC Privilege mode.
CLI Basics
49