Users Guide

Defaults none
Command Modes PRIORITY-GROUP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
and S4048–
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: Please note that Dell Networking does not recommended to use this command as it has
been deprecated in the current 9.4.(0.0) release. A warning message appears when you try to run
this command indicating that you have to use the dcb-map commands in the future.
Related Commands
• priority-list — congures the 802.1p priorities.
scheduler
Congure the method used to schedule priority trac in port queues.
Syntax
scheduler value
To remove the congured priority schedule, use the no scheduler command.
Parameters
value Enter schedule priority value. The range: strict: strict-priority trac is serviced
before any other queued trac.
Defaults Weighted Elastic Round Robin (WERR) scheduling is used to queue priority trac.
Command Modes POLICY-MAP-OUT-ETS
Command History
This guide is platform-specic. For command information about other platformsand S4048–, refer to the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
dot1p priority trac on the switch is scheduled to the current queue mapping. dot1p priorities within the
same queue must have the same trac properties and scheduling method.
ETS-assigned scheduling applies only to data queues, not to control queues.
510
Data Center Bridging (DCB)