Users Guide

The conguration of bandwidth allocation and strict-queue scheduling is not supported at the same time for
a priority group. If you congure both, the congured bandwidth allocation is ignored for priority-group
trac when you apply the output policy on an interface.
If you enable this command for a QoS ETS output policy, no bandwidth percentage is assigned to the policy.
Related Commands
• qos-policy-output ets — congures the ETS bandwidth allocation.
• bandwidth-percentage — bandwidth percentage allocated to priority trac in port queues.
show interface ets
Displays the ETS conguration applied to egress trac on an interface, including priority groups with priorities and bandwidth
allocation.
Syntax
show interface port-type slot/port[] ets {summary | detail}
Parameters
port-type slot/
port[] ets
Enter the port-type slot and port ETS information.
{summary | detail} Enter the keyword summary for a summary list of results or enter the keyword
detail for a full list of results.
NOTE: This command also enables you to view information corresponding to a range of ports.
However, for Open Networking (ON) platforms the notation for specifying port range in the
command is dierent from how you specify in non-ON platforms.
•
For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want
to display information corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1/1 - 1/1/4.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Added support to display the interface congurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Down status messages added.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Data Center Bridging (DCB)
511