Users Guide

Related Commands show ip cam stack-unit – Display content-addressable memory (CAM) entries for an S-Series switch.
ip ecmp weighted
Enables weighted ECMP calculations.
Syntax
ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted command.
Defaults N/A
Command Modes CONFIGURATION
Command History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
Enabling this CLI would inform the FIB to re-program the destination prex paths with weights in the
HW/CAM on the y.
If disabled, the CLI would inform the FIB to re-program the destination prex paths with no weights or
regular ECMP.
Example
Dell(conf)#ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)#ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)#no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)#no ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when trac distribution begins being monitored on an ECMP link bundle.
S4820T
Syntax
link-bundle-distribution trigger-threshold [percent]
To exit from ecmp group mode, use the exit command.
Parameters
percent Indicate the threshold value when trac distribution starts being monitored on an
ECMP link bundle. The range is from 1 to 90%. The default is 60%.
Equal Cost Multi-Path (ECMP)
613