Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or
switchport. To place an interface in Layer 2 mode, ensure that the interface’s conguration does not contain
an IP address and enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default
conguration. To delete a tunnel interface, use the no interface tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel
destination is over a physical interface. If you select any other interface as the next hop to the tunnel
destination, the tunnel interface does not operate as an ECMP.
Example
Dell(conf)#int tengigabitethernet 1/10
Dell(conf-if-te-1/10)#exit
Dell(conf)#
Related Commands
interface loopback — congures a Loopback interface.
interface null — congures a Null interface.
interface port-channel — congures a port channel.
interface vlan — congures a VLAN.
show interfaces — displays the interface conguration.
interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set of congurations on a group
of interfaces.
S4820T
Syntax
interface group [fortyGigE slot/port { - port }| tengigabitethernet slot/
port { - port } | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command:
Interfaces
711