Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced
Example (Single
Range)
This example shows the macro named test that was dened earlier.
Dell(config)#interface range macro test
Dell(config-if-range-te-1/1-3,te-5/1-47,te-13/1-89)#
Dell
Related Commands
interface range — congures a range of command (bulk conguration).
interface range macro (dene) — denes a macro for an interface range (bulk conguration).
interface vlan
Congure a VLAN. You can congure up to 4094 VLANs.
S4820T
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
vlan-id Enter a number as the VLAN Identier. The range is from 1 to 4094.
of-instance{of-id} Enter the keyword of-instance then the OpenFlow instance ID to add the VLAN to
the specied OpenFlow instance. The range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN when the VLAN is
created. An existing VLAN cannot be associated with an OpenFlow
instance.
Defaults Not congured, except for the Default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
720
Interfaces