Users Guide

Layer 2
Overhead
Link MTU and IP MTU Delta
Untagged Packet
with VLAN-Stack
Header
22 bytes
Tagged Packet with
VLAN-Stack
Header
26 bytes
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port congured this way is identied as a hybrid
port in report displays.
S4820T
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode
hybrid command.
Defaults non-hybrid
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
The following describes the interface command shown in the following example. This example sets a
port as hybrid, makes the port a tagged member of VLAN 20, and an untagged member of VLAN 10, which
becomes the native VLAN of the port. The port now accepts:
• untagged frames and classify them as VLAN 10 frames
Interfaces
729