Users Guide

• VLAN 20 tagged frames
The following describes the do show interfaces command shown in the following example. This
example shows output with “Hybrid” as the newly added value for 802.1QTagged. The options for this eld
are:
• True — port is tagged
• False — port is untagged
• Hybrid — port accepts both tagged and untagged frames
The following describes the interface vlan command shown in the following example. This example
shows unconguration of the hybrid port using the
no portmode hybrid command.
NOTE: Remove all other congurations on the port before you can remove the hybrid
conguration from the port.
Example
Dell(conf)#interface tengigabitethernet 7/1
Dell(conf-if-gi-7/0)#portmode hybrid
Dell(conf-if-gi-7/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged tengigabitethernet 7/1
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged tengigabitethernet 7/1
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: TenGigabitEthernet 7/1
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged tengigabitethernet 7/1
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged tengigabitethernet 7/1
Dell(conf-if-vl-20)#interface tengigabitethernet 7/1
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
rate-interval
Congure the trac sampling interval on the selected interface.
S4820T
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect trac data. The range is from 5
to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the
entered value. For example, if 44 seconds is designated, it rounds to 30; 45
to 59 seconds rounds to 45.
Defaults 299 seconds
730
Interfaces