Users Guide

Example
Dell(conf)#interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-gi-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specic physical interface or virtual interface.
S4820T
Syntax
show interfaces interface-type slot/port/
Parameters
interface Enter one of the following keywords and slot/port or number information:
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
For stack-units, enter the keywords stack-unit then the slot/port
information.
For a Null interface, enter the keyword null then the Null interface number.
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
NOTE: This command also enables you to view information corresponding
to a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is dierent from how
you specify in non-ON platforms.
For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]
. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces
interface-type 1/1/1 - 1/1/4.
Command Modes
EXEC
EXEC Privilege
Interfaces
733