Users Guide

between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces
interface-type 1/1/1 - 1/1/4.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Added support to display the interface congurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage Information The following describes the show interfaces gigabitethernet command following example.
Mode Control Indicates if auto negotiation is enabled. If so, indicates the selected speed
and duplex.
Mode Status Displays auto negotiation fault information. When the interface completes auto
negotiation successfully, the autoNegComplete eld and the linkstatus eld
read “True.”
AutoNegotiation
Advertise
Displays the control words the local interface advertises during negotiation. Duplex
is either half or full. Asym- and Sym Pause is the types of ow control the local
interface supports.
AutoNegotiation
Remote Partner’s
Ability
Displays the control words the remote interface advertises during negotiation.
Duplex is either half or full. Asym- and Sym Pause is the types of ow control the
remote interface supports.
AutoNegotiation
Expansion
ParallelDetectionFault is the handshaking scheme in which the link partner
continuously transmit an “idle” data packet using the Fast Ethernet MLT-3
waveform. Equipment that does not support auto-negotiation must be congured
to exactly match the mode of operation as the link partner or else no link can be
established.
742
Interfaces