Users Guide

0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 3w0d17h
TenGigabitEthernet 1/2 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:4c:f2:83
Current address is 00:01:e8:4c:f2:83
!-------------output truncated ----------------!
Related Commands
show hardware stack-unit — displays data plane and management plane input/output statistics.
show interfaces — displays information on a specic physical interface or virtual interface.
show interfaces status
To display status information on a specic interface only, display a summary of interface information or specify a stack-unit slot and
interface.
S4820T
Syntax
show interfaces [interface | stack—unit slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a Loopback interface, enter the keyword loopback then the slot/port
information. The range is from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
NOTE: This command also enables you to view information corresponding
to a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is dierent from how
you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces
interface-type 1/1/1 - 1/1/4.
Defaults
none
Command Modes
• EXEC
Interfaces
745