Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display ows for
switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed
packets).
The show port-channel-flow command returns the egress port identication in a given port-channel
if a valid ow is entered. A mismatched ow error occurs if MAC-based hashing is congured for a Layer 2
interface and you are trying to display a Layer 3 ow.
The output displays three entries:
• Egress port for unfragmented packets.
• In the event of fragmented packets, the egress port of the rst fragment.
• In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown
unicast, multicast, or broadcast trac is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
• Load-balance is congured for MAC
• Load-balance is congured for IP 4-tuple/2-tuple
• A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
Dell#show port-channel-flow outgoing-port-channel 1 incoming-interface te
3/3
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te 13/2
Time Domain Reectometer (TDR) Commands
TDR is useful for troubleshooting an interface that is not establishing a link; either it is apping or not coming up at all. TDR detects
open or short conditions of copper cables on 100/1000 Base-T modules.
Important Points to Remember
• The interface and port must be enabled (congured—refer to the interface command) before running TDR. An error
message is generated if you have not enabled the interface.
• The interface on the far-end device must be shut down before running TDR.
• Because TDR is an intrusive test on an interface that is not establishing a link, do not run TDR on an interface that is passing
trac.
• When testing between two devices, do not run the test on both ends of the cable.
778
Interfaces