Users Guide

7 0 1312
6 0 1312
5 0 1312
4 0 1312
3 0 1312
2 0 1312
1 0 1312
0 0 8
Dell#
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number} | vrf
vrf-name {ip-address mask [longer-prefixes [ecmp-group detail]]}| ecmp-
group {detail | member-info [detail [group-index index-number]]}| summary]
Parameters
stack-unit-number Enter the stack-unit ID.
port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-pipe. The
unit ID range is from 0 to 0.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display CAM entries
corresponding to that VRF.
network mask
[longer-prexes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only. You can enter one of the following keywords to lter results.
• Enter the keyword longer-prefixes to view routes with a common prex.
• Enter the keyword ecmp-group detail to view the ECMP group index.
ecmp-group {detail
| member-info
[detail [group-index
index-number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the following keywords
to lter results.
• Enter the keyword detail to view the ECMP group index.
• Enter the keyword member-info to view the member information for the
ECMP group.
•
Enter the keyword member-info detail to view detailed ECMP
membership and n-hop information.
• Enter the keyword group-index then the index number to show ECMP
membership per group. The range is from 0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prexes and
the total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
842
IPv4 Routing