Users Guide

Usage Information The following describes the show ip fib command shown in the following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly connected route or
the remote IP address used to forward the trac.
First-Hop Displays the rst hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
Index Displays the internal interface number.
EC Displays the number of ECMP paths.
Example
Dell>show ip fib linecard 12
Destination Gateway First-Hop Mac-Addr
Port VId Index EC
---------------------------------------------------------
3.0.0.0/8 via 100.10.10.10, So 2/8 100.10.10.10
00:01:e8:00:03:ff So 2/8 0 60260 0
3.0.0.0/8 via 101.10.10.10, So 2/900.10.10.0/24 Direct, So 2/8
0.0.0.0
00:01:e8:00:03:ff So 2/8 0 11144 0
100.10.10.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 3276 0
100.10.10.10/32 via 100.10.10.10, So 2/8 100.10.10.10
00:01:e8:00:03:ff So 2/8 0 0 0
101.10.10.0/24 Direct, So 2/9 0.0.0.0
00:00:00:00:00:00 RP2 0 11145 0
101.10.10.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 3277 0
101.10.10.10/32 via 101.10.10.10, So 2/9 101.10.10.10
00:01:e8:01:62:32 So 2/9 0 1 0
Dell>
show ip
b stack-unit
View all Forwarding Information Base (FIB) entries of a specic stack-unit.
S4820T
Syntax
show ip fib stack-unit id vrf vrf-name [ip-address [mask] [longer-prefixes]
| summary]
Parameters
id Enter the S-Series stack unit ID. The unit ID range is from 0 to 11 for the S4820T.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view FIB entries
corresponding to that VRF.
ip-address mask (OPTIONAL) Enter the IP address of the network destination to view only
information on that destination. Enter the IP address in dotted decimal format
(A.B.C.D). Enter the mask in slash prex format (/X).
IPv4 Routing
845