Users Guide

Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view information on
the IP routes corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip route summary shown in the following example.
Column Heading Description
Route Source Identies how the route is congured in Dell Networking OS.
Active Routes Identies the best route if a route is learned from two protocol sources.
Non-active Routes Identies the back-up routes when a route is learned by two dierent protocols. If
the best route or active route goes down, the non-active route becomes the best
route.
ospf 100 If routing protocols (OSPF, RIP) are congured and routes are advertised, then
information on those routes is displayed.
Total 1388 active... Displays the number of active and non-active routes and the memory usage of
those routes. If there are no routes congured in the Dell Networking OS, this line
does not appear.
Example
Dell>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
IPv4 Routing
859