Owners Manual

ETS Prerequisites and Restrictions
The following prerequisites and restrictions apply when you configure ETS bandwidth allocation or queue
scheduling and apply a DCB output policy on an interface.
• Configuring ETS bandwidth allocation or a queue scheduler for dot1p priorities in a priority group is
applicable if the DCBx version used on a port is CIN (refer to Configuring DCBx).
• When allocating bandwidth or configuring a queue scheduler for dot1p priorities in a priority group on
a DCBx CIN interface, take into account the CIN bandwidth allocation (refer to Configuring
Bandwidth Allocation for DCBx CIN) and dot1p-queue mapping.
NOTE: The IEEE 802.1Qaz, CEE, and CIN versions of ETS are supported.
Creating an ETS Priority Group
An ETS priority group specifies the range of 802.1p priority traffic to which a QoS output policy with ETS
settings is applied on an egress interface. You can associate a priority group to more than one ETS output
policy on different interfaces.
1. Configure a DCB Map.
CONFIGURATION mode
dcb-map dcb-map-name
The dcb-map-name variable can have a maximum of 32 characters.
2. Create an ETS priority group to use with an ETS output policy.
CONFIGURATION mode
priority-group group-num {bandwidth bandwidth | strict-priority} pfc off
The range for priority group is from 0 to 7.
Set the bandwidth in percentage. The percentage range is from 1 to 100% in units of 1%.
Committed and peak bandwidth is in megabits per second. The range is from 0 to 40000.
Committed and peak burst size is in kilobytes. Default is 50. The range is from 0 to 10000.
3. Specify the dot1p priority-to-priority group mapping for each priority.
priority-pgid dot1p0_group_num dot1p1_group_num ...dot1p7_group_num
Priority group range is from 0 to 7. All priorities that map to the same queue must be in the same
priority group.
Leave a space between each priority group number. For example: priority-pgid 0 0 0 1 2 4 4 4 in
which priority group 0 maps to dot1p priorities 0, 1, and 2; priority group 1 maps to dot1p priority 3;
priority group 2 maps to dot1p priority 4; priority group 4 maps to dot1p priorities 5, 6, and 7.
ETS Operation with DCBx
The following section describes DCBx negotiation with peer ETS devices.
In DCBx negotiation with peer ETS devices, ETS configuration is handled as follows:
280
Data Center Bridging (DCB)