Reference Guide

Link Layer Discovery Protocol (LLDP) | 1019
advertise med voice
c e s
Configure the system to advertise a dedicated IP telephony handset or other
appliances supporting interactive voice services.
Syntax
advertise med voice
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med voice {vlan-id layer2_priority
DSCP_value} |
{priority-tagged number} command.
Parameters
Defaults
unconfigured
Command Modes
CONFIGURATION (conf-lldp)
Command
History
Related
Commands
advertise med voice-signaling
c e s
Configure the system to advertise when voice control packets use a separate network
policy than voice data.
Syntax
advertise med voice-signaling
{vlan-id layer2_priority DSCP_value} | {priority-tagged
number}
show lldp neighbors Display the LLDP neighbors
show lldp neighbors Display the LLDP running configuration
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority (C-Series and E-Series only).
Range: 0 to 7
DSCP_value
Enter the DSCP value (C-Series and E-Series only).
Range: 0 to 63
priority-tagged number
Enter the keyword priority-tagged followed the Layer 2 priority.
Range: 0 to 7
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series and E-Series
debug lldp interface Debug LLDP
show lldp neighbors Display the LLDP neighbors
show running-config lldp Display the LLDP running configuration