Reference Guide

Multicast Source Discovery Protocol (MSDP) | 1023
To turn debugging off, use the no debug ip msdp {event peer address | packet peer
address | pim
} command.
Parameters
Defaults
Not configured
Command Modes
EXEC Privilege
Command
History
ip msdp cache-rejected-sa
e
Enable a MSDP cache for the rejected source-active entries.
Syntax
ip msdp cache-rejected-sa
{number}
To clear the MSDP rejected source-active entries, use the
no ip msdp cache-rejected-sa
{number} command followed by the ip msdp cache-rejected-sa {number} command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Related
Commands
event peer address
Enter the keyword event followed by the peer address in a dotted
decimal format (A.B.C.D.).
packet peer address
Enter the keyword packet followed by the peer address in a dotted
decimal format (A.B.C.D.).
pim
Enter the keyword pim to debug advertisement from PIM.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 6.2.1.1 Introduced
number
Enter the number of rejected SA entries to cache.
Range: 0 to 32766
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.4.1.0 Introduced
show ip msdp sa-cache rejected-sa Description.