Reference Guide

1024 | Multicast Source Discovery Protocol (MSDP)
www.dell.com | support.dell.com
ip msdp default-peer
e
Define a default peer from which to accept all Source-Active (SA) messages.
Syntax
ip msdp default-peer peer address
[list name]
To remove the default peer, use the
no ip msdp default-peer {peer address} list name
command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted.
You can enter multiple default peer commands.
ip msdp log-adjacency-changes
e
Enable logging of MSDP adjacency changes.
Syntax ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter this keyword and specify a standard access list that contains the RP
address that should be treated as the default peer. If no access list is
specified, then all SAs from the peer are accepted.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Added the
list option, and removed the prefix-list option.
Version 6.2.1.1 Introduced
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 6.2.1.1 Introduced