Reference Guide

1026 | Multicast Source Discovery Protocol (MSDP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip msdp peer
e
Configure an MSDP peer.
Syntax
ip msdp peer peer address
[connect-source] [description] [sa-limit number]
To remove the MSDP peer, use the
no ip msdp peer peer address [connect-source
interface
] [description name] [sa-limit number] command.
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number
from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1
to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed
by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 6.2.1.1 Introduced