Reference Guide

1052 | Multicast
www.dell.com | support.dell.com
Related
Commands
ip multicast-lag-hashing
e
Distribute multicast traffic among Port Channel members in a round-robin fashion.
Syntax ip multicast-lag-hashing
To revert to the default, enter no ip multicast-lag-hashing.
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
By default, one Port Channel member is chosen to forward multicast traffic. With this
feature turned on, multicast traffic will be distributed among the Port Channel
members in a round-robin fashion. This feature applies to the routed multicast traffic.
If IGMP Snooping is turned on, this feature also applies to switched multicast traffic.
Related
Commands
ip multicast-limit
c e s
Use this feature to limit the number of multicast entries on the system.
Syntax ip multicast-limit limit
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Version 8.3.7.0 Introduced on S4810
E-Series legacy command
show ip mroute View the E-Series routing table.
Version 6.3.1.0 Introduced for E-Series
ip multicast-limit Enable IP multicast forwarding.
limit
Enter the desired maximum number of multicast entries on the system.
E-Series Range: 1 to 50000
E-Series Default: 15000
C-Series Range: 1 to 10000
C-Series Default: 4000
S-Series Range: 1 to 2000
S-Series Default: 400