Reference Guide

Multicast | 1059
Usage
Information
Static mroutes are used by network administrators to control the reach-ability of the
multicast sources. If a PIM registered multicast source is reachable via static mroute
as well as unicast route, the distance of each route is examined and the route with
shorter distance is the one the PIM selects for reach-ability.
Note: The default distance of mroutes is zero (0) and is CLI configurable on a per route basis.
Example
FTOS#show ip rpf
RPF information for 10.10.10.9
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
show queue backplane multicast
e
Display the backplane bandwidth configuration about how much bandwidth is
dedicated to multicast versus unicast.
Syntax show queue backplane multicast bandwidth-percentage
Defaults
None
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS#show queue backplane multicast bandwidth-percent
Configured multicast bandwidth percentage is 80
Related
Commands
IPv6 Multicast Commands
IPv6 Multicast commands are:
• clear ipv6 mroute
• debug ipv6 mld_host
• ipv6 multicast-limit
• ip multicast-limit
• show ipv6 mroute
• show ipv6 mroute mld
• show ipv6 mroute summary
Version 7.7.1.0 Introduced on E-Series
queue backplane
multicast
Reallocate the amount of bandwidth dedicated to multicast traffic.