Reference Guide

1060 | Multicast
www.dell.com | support.dell.com
clear ipv6 mroute
e
Clear learned multicast routes on the multicast forwarding table. To clear the PIM tib,
use clear ip pim tib command.
Syntax
clear ipv6 mroute {group-address [source-address] | *}
Parameters
Defaults
No default behavior or values
Command Modes
EXEC Privilege
Command
History
Related
Commands
debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/port-range]
Use the no debug ipv6 mld_host command to discontinue collection of debug information for
the MLD host transactions.
Parameters
Default
Disabled
Command Modes
EXEC
group-address
[
source-address]
Enter multicast group address and source address (if desired) to clear
information on a specific group. Enter the addresses in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zero.
*
Enter * to clear all multicast routes.
Version 7.4.1.0 Introduced
show ipv6 pim tib Display the IPv6 PIM Tree Information Base.
int-count Enter the keyword count to indicate the number of required debug messages.
interface type Enter the following keywords and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet
followed by the slot/port information.
• For a 10G Ethernet interface, enter the keyword tengigabitethernet
followed by the slot/port information.
• For a 40G interface, enter the keyword fortyGigE followed by the slot/port
information.
• For a management interface enter the keyword managementinterface
followed by the slot/port information.
• For a port-channel interface, enter the keyword port-channel followed by
the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by the slot/port
information.