Reference Guide

Open Shortest Path First (OSPFv2) | 1089
Parameters
Defaults
Not configured.
Command Modes
ROUTER OSPF
Command
History
distribute-list out
c e s
Apply a filter to restrict certain routes destined for the local routing table after the
SPF calculation.
Syntax
distribute-list prefix-list-name out [bgp | connected | isis | rip | static]
To remove a filter, use the
no distribute-list prefix-list-name out [bgp | connected |
isis | rip | static] command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface
(OPTIONAL) Enter one of the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Port Channel groups, enter the keyword
port-channel followed by
a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1-32 for EtherScale, 1-255 for TeraScale
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
prefix-list-name
Enter the name of a configured prefix list.
bgp
(OPTIONAL) Enter the keyword bgp to specify that BGP routes are
distributed.*
connected
(OPTIONAL) Enter the keyword connected to specify that connected routes
are distributed.
isis (OPTIONAL) Enter the keyword isis to specify that IS-IS routes are
distributed.*