Reference Guide

1096 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
To return to default value, enter no ip ospf cost.
Parameters
Defaults
The default cost is based on the reference bandwidth.
Command Modes
INTERFACE
Command
History
Usage
Information
If this command is not configured, cost is based on the auto-cost command.
When you configure OSPF over multiple vendors, use the ip ospf cost command to
ensure that all routers use the same cost. Otherwise, OSPF routes improperly.
Related
Commands
ip ospf dead-interval
c e s
Set the time interval since the last hello-packet was received from a router. After the
interval elapses, the neighboring routers declare the router dead.
Syntax
ip ospf dead-interval seconds
To return to the default values, enter no ip ospf dead-interval.
Parameters
Defaults
40 seconds
Command Modes
INTERFACE
Command
History
cost
Enter a number as the cost.
Range: 1 to 65535.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
auto-cost Control how the OSPF interface cost is calculated.
seconds
Enter the number of seconds for the interval.
Range: 1 to 65535. Default: 40 seconds.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series