Reference Guide

Open Shortest Path First (OSPFv2) | 1109
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
Usage
Information
You must have an IP address assigned to an interface to enter the ROUTER OSPF
mode and configure OSPF.
Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot
be used again in the system.
show config
c e s
Display the non-default values in the current OSPF configuration.
Syntax
show config
Command Modes
ROUTER OSPF
Command
History
Example
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
process-id
Enter a number for the OSPF instance.
Range: 1 to 65535.
vrf name (Optional) E-Series Only: Enter the VRF process identifier to tie the OSPF
instance to the VRF. All network commands under this OSPF instance are
subsequently tied to the VRF instance.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.9.1.0 Introduced VRF
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series