Reference Guide

1110 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
show ip ospf
c e s
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf command
output will not list Area 0.
Example
FTOS#show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
FTOS#
process-id Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
vrf name E-Series Only: Show only the OSPF information tied to the VRF process.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.8.0 Added output for LSA throttling timers
Version 8.3.7.0 Introduced on S4810
Version 7.9.1.0 Introduced VRF
Version 7.9.1.0 Introduced VRF
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.8.1.0 Introduced process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Table 37-2. Command Output Descriptions: show ip ospf process-id
Line Beginning with Description
“Routing Process...” Displays the OSPF process ID and the IP address associated with
the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...” Displays the delay and hold time configured for this process ID.