Reference Guide

Open Shortest Path First (OSPFv2) | 1127
Example
FTOS>show ip ospf int
GigabitEthernet 13/17 is up, line protocol is up
Internet Address 192.168.1.2/30, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.253.2, Interface address 192.168.1.2
Backup Designated Router (ID) 192.168.253.1, Interface address 192.168.1.1
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 192.168.253.1 (Backup Designated Router)
GigabitEthernet 13/23 is up, line protocol is up
Internet Address 192.168.0.1/24, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DROTHER, Priority 1
Designated Router (ID) 192.168.253.5, Interface address 192.168.0.4
Backup Designated Router (ID) 192.168.253.3, Interface address 192.168.0.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:08
Neighbor Count is 3, Adjacent neighbor count is 2
Adjacent with neighbor 192.168.253.5 (Designated Router)
Adjacent with neighbor 192.168.253.3 (Backup Designated Router)
Loopback 0 is up, line protocol is up
Internet Address 192.168.253.2/32, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type LOOPBACK, Cost: 1
Loopback interface is treated as a stub Host.
FTOS>
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Table 37-10. Command Example Descriptions: show ip ospf process-id
interface
Line beginning with Description
GigabitEthernet... This line identifies the interface type slot/port and the status of the OSPF
protocol on that interface.
Internet Address... This line displays the IP address, network mask and area assigned to this
interface.
Process ID... This line displays the OSPF Process ID, Router ID, Network type and
cost metric for this interface.
Transmit Delay... This line displays the interface’s settings for Transmit Delay, State, and
Priority. In the State setting, BDR is Backup Designated Router.
Designated Router... This line displays the ID of the Designated Router and its interface
address.
Backup Designated... This line displays the ID of the Backup Designated Router and its
interface address.
Timer intervals... This line displays the interface’s timer settings for Hello interval, Dead
interval, Transmit Delay (Wait), and Retransmit Interval.