Reference Guide

PIM-Sparse Mode (PIM-SM) | 1143
Usage
Information
This command is applied to the subsequent PIM-BSR. Existing BSR advertisements
are cleaned up by time out. Candidate RP advertisements can be cleaned using the
clear ip pim rp-mapping command.
ip pim bsr-candidate
c e s
Configure the PIM router to join the Bootstrap election process.
Syntax
ip pim bsr-candidate interface
[hash-mask-length] [priority]
To return to the default value, enter
no ip pim bsr-candidate.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length.
Range: zero (0) to 32
Default: 30
priority
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: zero (0)
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 6.1.1.0 Added support for VLAN interface