Reference Guide

1148 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
The access name is an extended IP access list that denies PIM register packets to RP
at the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list.
ip pim rp-address
c e s
Configure a static PIM Rendezvous Point (RP) address for a group or access-list.
Syntax
ip pim rp-address
address {group-address group-address mask} override
To remove an RP address, use the no ip pim rp-address address {group-address
group-address mask} override command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced
address
Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address mask
Enter the keyword
group-address followed by a group-address mask,
in dotted decimal format (/xx), to assign that group address to the RP.
override
Enter the keyword override to override the BSR updates with static
RP. The override will take effect immediately during enable/disable.
Note: This option is applicable to multicast group range.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series
pre-Version 6.1.1.1 Introduced on E-Series