Reference Guide

1166 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the
no ipv6 pim bsr-candidate command.
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Command
History
ipv6 pim dr-priority
e
Change the Designated Router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
Defaults
1
Command Modes
INTERFACE
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length for RP selection.
Range: 0 to 128
Default: 126
priority
(OPTIONAL) Enter the priority value for Bootstrap election process.
Range: 0 to 255
Default: 0
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
priority-value Enter a number. Preference is given to larger/higher number.
Range: 0 to 4294967294
Default: 1