Reference Guide

1170 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
ipv6 pim rp-candidate
e
Specify an interface as an RP candidate.
Syntax
ipv6 pim rp-candidate interface [priority-value]
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
ipv6 pim sparse-mode
e
Enable IPv6 PIM sparse mode on the interface.
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, enter no ipv6 pim sparse-mode.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by
a number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
priority-value (OPTIONAL) Enter a number as the priority of this RP Candidate, which is
included in the Candidate-RP-Advertisements.
Range: 0 (highest) to 255 (lowest)
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Version 8.3.19.0 Introduced on S4820T