Reference Guide

Port Monitoring | 1181
Example
FTOS#show monitor session 11
SessionID Source Destination Direction Mode
--------- ------ ------------- --------- -------
11 Gi 10/0 Gi 10/47 rx interface
Related
Commands
show running-config monitor session
c e s
Display the running configuration of all monitor sessions or a specific session.
Syntax show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use just the show
running-config monitor session
command.
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS#show running-config monitor session
!
monitor session 8
source GigabitEthernet 10/46 destination GigabitEthernet 10/1 direction rx
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet 10/47 direction rx
FTOS#show running-config monitor session 11
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet 10/47 direction rx
Usage
Information
The monitoring command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Related
Commands
monitor session Create a session for monitoring.
session-ID
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
monitor session Create a session for monitoring.
show monitor session Display a monitor session.