Reference Guide

1182 | Port Monitoring
www.dell.com | support.dell.com
source (port monitoring)
c e s
Configure a port monitor source.
Syntax
source
interface destination interface direction {rx | tx | both}
To disable a monitor source, use the
no source interface destination interface direction {rx
| tx | both} command.
Parameters
Defaults
No default behavior or values
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Example
FTOS(conf-mon-sess-11)#source gi 10/0 destination gi 10/47 direction rx
FTOS(conf-mon-sess-11)#
Usage
Information
interface Enter the one of the following keywords and slot/port
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by
the slot/port information.
destination
Enter the keyword destination to indicate the interface
destination.
direction {rx | tx | both}
Enter the keyword direction followed by one of the packet
directional indicators.
rx: to monitor receiving packets only
tx: to monitor transmitting packets only
both: to monitor both transmitting and receiving packets
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
Note: A SONET port can only be configured as a monitored port.