Reference Guide

Quality of Service (QoS) | 1209
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE
Command
History
Usage
Information
The dot1p-priority command changes the priority of incoming traffic on the interface. The
system places traffic marked with a priority in the correct queue and processes that traffic
according to its queue.
When you set the priority for a Port Channel, the physical interfaces assigned to the Port
Channel are configured with the same value. You cannot assign dot1p-priority command to
individual interfaces in a Port Channel.
rate limit
e
Limit the outgoing traffic rate on the selected interface.
Syntax
rate limit [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] [vlan vlan-id]
priority-value
Enter a value from 0 to 7.
dot1p Queue Number
02
10
21
33
44
55
66
77
For the C-Series and S-Series, enter a value 0, 2, 4, or 6
dot1p Queue Number
01
10
20
31
42
52
63
73
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series