Reference Guide

1212 | Quality of Service (QoS)
www.dell.com | support.dell.com
E-Series
On one interface, you can configure the rate limit or rate police command for a VLAN or you
can configure the
rate limit or the rate police command for the interface.
For each physical interface, you can configure six rate police commands specifying different
VLANS.
After configuring VLANs in the rate police command, if this error message appears:
%Error: Specified VLANs overlap with existing config.
Check to if the same VLANs are used with the
rate limit command on other interfaces. To
clear the problem, remove the
rate limit configuration(s), and re-configure the rate police
command. After the rate police command is configured, return to the other interfaces and
re-apply the
rate limit configuration.
Related
Commands
rate shape
c e s
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
Defaults
Granularity for rate is Mbps unless the kbps option is used.
Command Modes
INTERFACE
Command
History
rate-police Police traffic output as part of the designated policy.
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps).
On C-Series and S-Series make the following value a multiple of 64. The
default granularity is Megabits per second (Mbps).
Range: 0-10000000
rate Enter the outgoing rate in multiples of 10 Mbps.
Range: 10 to 10000
burst-KB (OPTIONAL) Enter a number as the burst size in KB.
Range: 0 to 10000
Default: 10
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Added
kbps option on C-Series, E-Series, and Series.
Version 7.6.1.0 Introduced on S-Series and on C-Series
pre-Version 6.1.1.1 Introduced on E-Series