Reference Guide

1230 | Quality of Service (QoS)
www.dell.com | support.dell.com
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
History
Usage
Information
Input policy map is used to classify incoming traffic to different flows using class-map, QoS
policy, or simply using incoming packets DSCP. This command enables policy-map-input
configuration mode (conf-policy-map-in).
Related
Commands
policy-map-output
c e s
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the
no policy-map-output policy-map-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Expanded to add support for Layer 2
pre-Version 6.1.1.1 Introduced on E-Series
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy input Apply an input policy map to the selected interface.
policy-map-name
Enter the name for the policy map in character format (16 characters
maximum).
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on C-Series and S-Series
pre-Version 6.1.1.1 Introduced on E-Series