Reference Guide

Quality of Service (QoS) | 1231
Usage
Information
Output policy map is used to assign traffic to different flows using QoS policy. This command
enables the policy-map-output configuration mode (conf-policy-map-out).
Related
Commands
qos-policy-input
c e s
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use
no qos-policy-input
qos-policy-name [layer2] command.
Parameters
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command to specify the name of the input QoS policy. Once input policy is
specified, rate-police can be defined. This command enables the qos-policy-input
configuration mode—(conf-qos-policy-in).
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy output Apply an output policy map to the selected interface.
qos-policy-name
Enter your input QoS policy name in character format (32 character
maximum).
layer2
(OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class
Map.
Default: Layer 3
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Expanded to add support for Layer 2