Reference Guide

Quality of Service (QoS) | 1233
queue backplane ignore-backpressure
e
Reduce egress pressure by ignoring the ingress backpressure
Syntax
queue backplane ignore-backpressure
To return to the default, use the no queue backplane ignore-backpressure command.
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
queue egress
e
Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for
the Multicast bandwidth queue.
Syntax
queue egress multicast linecard {slot number port-set number | all} [wred-profile name |
multicast-bandwidth percentage]
To return to the default, use the
no queue egress multicast linecard {slot number port-set
number | all} [wred-profile name | multicast-bandwidth percentage] command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Version 7.7.1.0 Introduced on E-Series
linecard number
Enter the keyword linecard followed by the line card slot number.
E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to
5 on a E300.
port-set number
Enter the keyword port-set followed by the line card’s port pipe.
Range: 0 or 1
all
Enter the keyword all to apply to all line cards.
wred-profile name
(OPTIONAL) Enter the keyword wred-profile followed by your
WRED profile name in character format (16 character maximum). Or
use one of the pre-defined WRED profile names.
Pre-defined Profiles:
wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g
multicast-bandwidth
percentage
(OPTIONAL) Enter the keyword multicast-bandwidth followed by
the bandwidth percentage.
Range: 0 to 100%
Version 7.5.1.0 Added support for multicast-bandwidth
Version 7.4.1.0 and 6.5.3.0 Introduced on E-Series