Reference Guide

Quality of Service (QoS) | 1235
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of queues.
The WRED Curve is applied to all eight ingress Multicast queues.
Related
Commands
rate-limit
e
Specify the rate-limit functionality on outgoing traffic as part of the selected policy.
Syntax
rate-limit [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
Parameters
Defaults
Burst size is 50 KB. peak-rate is by default the same as committed-rate. Granularity for
committed-rate and peak-rate is Mbps unless the kbps option is used.
Command Modes
QOS-POLICY-OUT
Command
History
Version 7.4.1.0 and 6.5.3.0 Introduced on E-Series
Note: The multicast-bandwidth option is not supported on queue ingress. If you
attempt to use the multicast-bandwidth option, the following reject error message is
generated:
% Error:Bandwidth-percent is not allowed for ingress multicast
show queue statistics ingress Display the ingress queue statistics
kbps
Enter this keyword to specify the rate limit in Kilobits per second
(Kbps). On the E-Series, Force10 recommends using a value greater
than or equal to 512 as lower values does not yield accurate results.
The default granularity is Megabits per second (Mbps).
Range: 0-10000000
committed-rate
Enter the committed rate in Mbps.
Range: 0 to 10000 Mbps
burst-KB
(OPTIONAL) Enter the burst size in KB.
Range: 16 to 200000 KB
Default: 50 KB
peak peak-rate
(OPTIONAL) Enter the keyword peak followed by the peak rate in
Mbps.
Range: 0 to 10000 Mbps
Default: Same as designated for
committed-rate
Version 8.2.1.0 Added kbps option on E-Series.
Version 7.7.1.0 Removed from C-Series