Reference Guide

Quality of Service (QoS) | 1237
rate-shape
c e s
Shape traffic output as part of the designated policy.
Syntax
rate-shape [kbps] rate [burst-KB]
Parameters
Defaults
Burst size is 10 KB. Granularity for rate is Mbps unless the kbps option is used.
Command Modes
QOS-POLICY-OUT
Command
History
Usage
Information
rate-shape can be applied only as an aggregate policy. If it is applied as a class-based policy,
then rate-shape will not take effect.
On 40-port 10G linecards, if the traffic is shaped between 64 and 1000kbs, for some values
the shaped rate is much less than the value configured. Do not use values in this range for 10G
interfaces.
Related
Commands
service-class dot1p-mapping
Configure a service-class criterion, based on a dot1p value.
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps).
On C-Series and S-Series make the following value a multiple of 64. The
default granularity is Megabits per second (Mbps).
Range: 0-10000000
rate Enter the outgoing rate in multiples of 10 Mbps.
Range: 10 to 10000
burst-KB (OPTIONAL) Enter a number as the burst size in KB.
Range: 0 to 10000
Default: 10
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Added
kbps option on C-Series, E-Series, and Series.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
rate shape Shape the traffic output of the selected interface.
qos-policy-output Create a QoS output policy.