Reference Guide

1238 | Quality of Service (QoS)
www.dell.com | support.dell.com
Syntax
service-class dot1p-mapping
{dot1p0 value | dot1p1 value | dot1p2 value | dot1p3 value | dot1p4
value | dot1p5value | dot1p6 <value> | dot1p7 value}
Parameters
Command Mode
INTERFACE
service-policy input
c e s
Apply an input policy map to the selected interface.
Syntax
service-policy input policy-map-name [layer2]
To remove the input policy map from the interface, use the
no service-policy input
policy-map-name [layer2] command.
Parameters
Defaults
Layer 3
Command Modes
INTERFACE
Command
History
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the service-policy
for those interfaces. A policy map attached to an interface can be modified.
dot1p0
value ...
dot1p7
value
Enter a dot1p list number and value
List number Range: 0 to 7
Range: 0 to 33
policy-map-name
Enter the name for the policy map in character format (16 characters
maximum). You can identify an existing policy map or name one
that does not yet exist.
layer2
(OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class
Map.
Default: Layer 3
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Expanded to add support for Layer 2
pre-Version 6.1.1.1 Introduced on E-Series
Note: The service-policy commands are not allowed on a port channel.
The
service-policy input policy-map-name command and the service-class dynamic
dot1p
command are not allowed simultaneously on an interface. However, the
service-policy input command (without the policy-map-name option) and the service-class
dynamic dot1p
command are allowed on an interface.