Reference Guide

1274 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Related
Commands
distance
c e s
Assign a weight (for prioritization) to all routes in the RIP routing table or to a
specific route. Lower weights (“administrative distance”) are preferred.
Syntax
distance weight [ip-address mask [prefix-name]]
To return to the default values, use the
no distance weight [ip-address mask] command.
Parameters
Defaults
weight
= 120
Command Modes
ROUTER RIP
Command
History
Related
Commands
distribute-list in
c e s
Configure a filter for incoming routing updates.
Syntax
distribute-list prefix-list-name in [interface]
To delete the filter, use the
no distribute-list prefix-list-name in command.
router rip Enter ROUTER mode on the switch.
weight
Enter a number from 1 to 255 for the weight (for prioritization).
The default is 120.
ip-address
(OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the
host or network to receive the new distance metric.
mask
If you enter an IP address, you must also enter a mask for that IP address, in
either dotted decimal format or /prefix format (/x)
prefix-name
(OPTIONAL) Enter a configured prefix list name.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
default-metric Assign one distance metric to all routes learned using the redistribute
command.