Reference Guide

1276 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Related
Commands
ip poison-reverse
c e s
Set the prefix of the RIP routing updates to the RIP infinity value.
Syntax
ip poison-reverse
To disable poison reverse, enter no ip poison-reverse.
prefix-list-name Enter the name of a configured prefix list.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale
and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
connected
(OPTIONAL) Enter the keyword connected to filter only directly
connected routes.
isis
(OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
Note: This option is only available on E-Series.
ospf
(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static
(OPTIONAL) Enter the keyword static to filter manually configured routes.
Version 8.3.19.0 Introduced on S4820T
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list.