Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1271

1280 | Routing Information Protocol (RIP)

www.dell.com | support.dell.com

Parameters

Defaults

Not configured.

Command Modes

ROUTER RIP

Command

History

Usage

Information

When a neighbor router is identified, unicast data exchanges occur. Multiple

neighbor routers are possible.

Use the passive-interface command in conjunction with the neighbor command to

ensure that only specific interfaces are receiving and sending data.

Commands

network

c e s

Enable RIP for a specified network. Use this command to enable RIP on all networks

connected to the switch.

Syntax

network ip-address

To disable RIP for a network, use the no network ip-address command.

Parameter

Defaults

No RIP network is configured.

Command Modes

ROUTER RIP

Command

History

ip-address

Enter the IP address, in dotted decimal format, of a router with which to exchange

information.

Version 8.3.19.0 Introduced on S4820T

Version 8.3.7.0 Introduced on S4810

Version 7.8.1.0 Introduced on S-Series

Version 7.6.1.0 Introduced on C-Series

pre-Version 6.2.1.1 Introduced on E-Series

passive-interface Sets the interface to only listen to RIP broadcasts.