Reference Guide

Routing Information Protocol (RIP) | 1281
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address specified by the network
command.
offset-list
c e s
Specify a number to add to the incoming or outgoing route metrics learned via RIP.
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the
no offset-list prefix-list-name {in | out} offset [interface]
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
prefix-list-name
Enter the name of an established Prefix list to determine which incoming
routes will be modified.
offset
Enter a number from zero (0) to 16 to be applied to the incoming route
metric matching the access list specified.
If you set an offset value to zero (0), no action is taken.
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.19.0 Introduced on S4820T
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series