Reference Guide

1282 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Usage
Information
When the offset metric is applied to an interface, that value takes precedence over an
offset value that is not extended to an interface.
Related
Commands
output-delay
c e s
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, enter no output-delay.
Parameters
Default
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
This command is intended for low-speed interfaces.
passive-interface
c e s
Suppress routing updates on a specified interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list.
delay
Specify a number of milliseconds as the delay interval.
Range: 8 to 50
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series