Reference Guide

Routing Information Protocol (RIP) | 1283
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
Although the passive interface will neither send nor receive routing updates, the
network on that interface will still be included in RIP updates sent via other
interfaces.
Related
Commands
redistribute
c e s
Redistribute information from other routing instances.
Syntax
redistribute {connected | static}
To disable redistribution, use the
no redistribute {connected | static} command.
interface
Enter the following information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512
for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.19.0 Introduced on S4820T
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
neighbor Enable RIP for a specified network.
network Define a neighbor.